Madam/sir,I haven't understood the assignment question madam/sir? There you put some conditions:-a)count=0 then LED should RESET (Simply we can't do this at one try, we can use an equal to compare instruction after using some vcounter type methodology and Add instructions as used in the Compare instruction Tutorial taught by you. Should we use that method here? If yes then where's the use of CTC counter in this lecture's assignment),b)count=1, LED should start BLINKING (I can do this),c)count=2, LED should SET (What do we mean by SET, Upto what you taught I haven't seen or learnt such instruction or condition).
448 visits
Outline:Connection of SMPS and USBasp to the Mainboard Example for CTC counter Insert a Contact and a CTC Insert a rung below Insert EQU and a Coil in the new rung Set the parameters for count Real-time simulation of CTC Working of CTC in simulation mode Make hardware connections for the CTC using Traffic light module and Switchboard module Demonstration of CTC on hardware
Connection of SMPS and USBasp to the Mainboard Example for CTC counter Insert a Contact and a CTC Insert a rung below Insert EQU and a Coil in the new rung Set the parameters for count Real-time simulation of CTC Working of CTC in simulation mode Make hardware connections for the CTC using Traffic light module and Switchboard module Demonstration of CTC on hardware
Show video info
Pre-requisite